Solar Cell Keeps Working Long After Sun Sets
By AMERICAN INSTITUTE OF PHYSICS
 |
| The device generates electricity at night from the temperature difference between the solar cell and its surroundings. Credit: Sid Assawaworrarit |
Harvesting energy from the temperature difference between photovoltaic cell, surrounding air leads to a viable, renewable source of electricity at night.
About 750 million people in the world do not have access to
electricity at night. Solar cells provide power during the day, but saving
energy for later use requires substantial battery storage.
In Applied Physics Letters, by
AIP Publishing, researchers from Stanford University constructed a photovoltaic
cell that harvests energy from the environment during the day and night,
avoiding the need for batteries altogether. The device makes use of the heat
leaking from Earth back into space – energy that is on the same order of
magnitude as incoming solar radiation.
At night, solar cells radiate and lose heat to the sky, reaching
temperatures a few degrees below the ambient air. The device under development
uses a thermoelectric module to generate voltage and current from the
temperature gradient between the cell and the air. This process depends on the
thermal design of the system, which includes a hot side and a cold side.
“You want the thermoelectric to have very good contact with both the cold side, which is the solar cell, and the hot side, which is the ambient environment,” said author Sid Assawaworrarit. “If you don’t have that, you’re not going to get much power out of it.”
The team demonstrated power generation in their device during the
day, when it runs in reverse and contributes additional power to the
conventional solar cell, and at night.
The setup is inexpensive and, in principle, could be incorporated
within existing solar cells. It is also simple, so construction in remote
locations with limited resources is feasible.
“What we managed to do here is build the whole thing from
off-the-shelf components, have a very good thermal contact, and the most
expensive thing in the whole setup was the thermoelectric itself,” said author
Zunaid Omair.
Using electricity at night for lighting requires a few watts of
power. The current device generates 50 milliwatts per square meter, which means
lighting would require about 20 square meters of photovoltaic area.
“None of these components were specifically engineered for this
purpose,” said author Shanhui Fan. “So, I think there’s room for improvement,
in the sense that, if one really engineered each of these components for our
purpose, I think the performance could be better.”
The team aims to optimize the thermal insulation and
thermoelectric components of the device. They are exploring engineering
improvements to the solar cell itself to enhance the radiative cooling
performance without influencing its solar energy harvesting capability.
Reference: “Nighttime electric power generation at a density of
50mW/m2 via radiative cooling of a photovoltaic cell” by Sid Assawaworrarit,
Zunaid Omair and Shanhui Fan5 April 2022, Applied Physics Letters.
DOI: 10.1063/5.0085205